How to fill water for water mist fireplace

How to fill water for water vapor fireplace .

1. Manually add water.

After plugging in the power, the voice prompt shows that the water level is insufficient. When you hear the voice prompt that the water is full, you can stop adding water to the water tank. Remember not to continue adding water at this time, otherwise water overflow will cause the short circuit. During use, the water will become less and less, and when the water level drops below half, it will prompt (insufficient water level, please add water). At this time, just fill up the water. If you do not add water in time, the water level will reach the lowest point and prompt (insufficient water level, turn off after 30 seconds). Just fill up the water to make it

2: Automatic fill water via button.

After connect power and press 1 times home button turn on , you can add water or drain water. The fifth button on the keypad is the "Add Water and Drain" button (press twice to add water, press again to stop adding water. Press and hold for 5 seconds to drain, press again to stop draining). Depending on the water level. When the water level is low, the "Add Water" function will start automatically until the water is full. It will stop working after the fireplace is turned on (when the water at the lowest level, it will prompt that the water level is insufficient, and it will shut down.

When the water level is at the startup level (in the startup state):

1. During the process of adding water, the machine starts to work and produce flame.

2. If water up to lowest level , it will prompt that the water is insufficient and please add water. When water up to highest level and remind you water is full that fireplace will be automatically stops adding water. (When turned on, it will prompt that the water is full.) (The flame effect is best after 15 minutes of use.)

 

3. Directly connect supply water system